Discussion on the precautions for adding oil to the gearbox

If the oil quantity is determined to be large compared to the actual oil quantity when the reducer is running, it is recommended to weigh the oil quantity and add an appropriate amount of smooth oil for the worm gear reducer when the reducer is finished running. Some gear reducer manufacturers have imitated orders to specify the oil quantity of worm gear reducers, and the oil quantity has increased to 2/3 of the oil window position. And this data is under shutdown conditions, be careful not to add lubricating oil while the worm gear reducer is running. Due to the fact that during the operation of the worm gear reducer, the internal components of the gear or worm gear drive the smooth oil inside to run together. If the oil level of the worm gear reducer is determined in this situation, it may be full, or it may be lower than 2/3 of the oil window, or even there may not be much smooth oil. When applying a new gearbox, after 300 hours of continuous operation, it is necessary to replace the oil. Afterwards, the oil needs to be replaced every 2500 hours of application. However, the quality of the oil should still be reviewed on schedule during the application process. If the oil has impurities, aging, or deterioration, it must be replaced at any time. The gear oil of fixed brand and number shall be applied to the reducer, and the oil phase of different brands, numbers or types shall not be mixed. During the oil change process, the interior of the gearbox should be thoroughly cleaned before injecting new oil. The above is the relevant content for the gearbox, hoping to be helpful to everyone.