What is servo control? Servo control refers to the effective control of changes in the position, velocity, and acceleration of object motion. It is one of the most important activities of human beings to generate motion and control the movement of objects for a certain purpose. There are usually three types of servo control methods: speed control, torque control, and position control. This article
the temperature of sliding bearings should not exceed 65 degrees Celsius, the temperature of the gearbox casing should be less than 80 degrees Celsius,
The fixing method of the embedded end cover is to use adjustment bolts, which is simple and can be used to fix bearings with adjustable clearance and reducers with high sealing requirements.
A reducer uses the transmission of gears at all levels to reduce speed.
Tooth breakage is a common fault in gears, and the fracture of transmission gears usually occurs on the teeth. Due to the high stress at the teeth, it is the source of stress. There are three common conditions for broken teeth:
The installation method of hard tooth surface gear reducers is a key component of the application and maintenance of hard tooth surface gear reducers. It ensures the normal operation of industrial equipment, the ratio of computer installation speed to computer installation
Servo motors are equipped with reducers to increase torque. It is not economical to blindly increase the power of the servo motor when the load is high. Therefore, select the appropriate reduction ratio reducer in the required speed range. The reducer itself is used to reduce speed and increase output torque. Connection mode between reducer and motor: Hold mode - Output shaft of servo motor extend
If the drive motor is not broken, but the output shaft of the reducer is broken, there are several possible causes besides poor concentricity of assembly at the output of the reducer. First, the wrong selection results in insufficient output of the gearbox. Some users mistakenly assume that as long as the rated output torque of the selected reducer meets the requirements of the work, it is not.
