News

The wear of the output shaft will significantly affect the transmission accuracy, operational stability, and service life of the BWE42-187-2.2 cycloidal pinwheel reducer. If not dealt with in a timely manner, it will cause chain failures. 1、 Core performance degradation performance 1. Reduced transmission efficiency After the output shaft wears out, the clearance between it and the coupling

Common faults and solutions of WD80-60-1 worm gear reducer are as follows: 1. Excessive oil temperature and severe heating Reason: Insufficient or deteriorated lubricating oil, incorrect oil grade, excessive load, tight assembly, blocked ventilation cap, poor heat dissipation. Solution: Add or replace VG220/320 worm gear oil; Reduce load; Check and adjust the meshing clearance and bearing

The correct installation and adjustment method for WD150-47-II worm gear reducer is as follows: 1、 Preparation before installation 1. Verify the model WD150-47-II, inspect the appearance for any bumps, cracks, or oil leaks, and ensure that the output and input shafts are not bent or deformed. 2. Clean the installation foundation, coupling, and keyway to ensure that there are no iron filin

The gear accuracy level of soft tooth surface reducers is usually selected as 8-9 levels (GB/T 10095), which can be increased to 7 levels in working conditions with high requirements for noise and smoothness. This choice requires a comprehensive consideration of transmission performance, cost control, and operating environment, taking into account manufacturing feasibility and long-term maintenanc

The shaft of ZS soft tooth surface reducer is usually made of 45 grade steel or 40Cr steel, and is quenched and tempered to meet the requirements of strength and wear resistance. 1、 Conventional selection of shaft materials 1. 45 steel (mainstream choice) Applicable scenarios: It is the most common shaft material in ZS series soft tooth surface reducers for medium and low speed, light loa

1、 Overall transmission structure design 1. Transmission series and principle This model of reducer adopts a two-stage worm gear transmission structure, which achieves a large transmission ratio output of 1:400 through the meshing transmission between the two-stage worm gear and the worm wheel. The first stage is high-speed transmission, with the worm connected to the motor output shaft, res

1、 Installation foundation and site requirements Installation foundation rigidity requirements This model of reducer is suitable for 4KW motors, and there is a certain vibration load during operation. It needs to be installed on a rigid concrete foundation or steel structure platform. The strength grade of the concrete foundation shall not be lower than C30, and the thickness shall not be less t

At room temperature (10 ℃~35 ℃), the replacement cycle of lubricating oil for SA97-40.38-4P-15KW reducer needs to be determined based on three core factors: lubricating oil type, operating conditions, and load status. The specific standards are as follows: 1、 Basic replacement cycle divided by lubricating oil type 1. Mineral type gear oil (such as VG46 #/VG68 # universal type, containing EP